Recent content by 2B-Inspired

How is this any different than what DJI has done all along?

I just received another notification, "one week left to renew" DJI Care Refresh. I also carry "hull coverage" through Global. I'm looking for opinions on whether it would be worth another $400 to renew the Refresh. Is there much benefit to having it for another year if I am already fully...

I have always responded to existing posts...... CAN'T FIGURE OUT WHERE TO POST NEW THREAD.... AM I BLIND?

Yes, overnight and completely dead. Not even a single light when test button was pressed. Charged fine and had remained charged for days. Haven't checked it since. The other battery was installed in the CS and was also checked for several days afterward and there was no indication of...

I have always done as you pointed out, press and hold then power off. I suppose it is possible that I simply forgot to shut down properly but this is the first time this has happened and I am having a hard time believe it was simply coincidence. Also, this was only over night, less than 24...

1/2 as worried? ;)

I just received my cendence and new replacement patch antenna from DJI but have yet to fly it. (The previous patch antenna lost signal at 500-1000 ft.) The night before, while planning a test flight, I confirmed the cendence recognized the patch antenna whereas the previous one did not. The...

Just shipped my cendence to DJI today. They say 8-10 business days....fingers crossed!

I haven't flown yet to see if it fixed mine, hopefully soon. As I stated above, mine is not even detected by the new firmware so I'm not betting on it.

Thanks Matthew! As with many other issues, it helps when the AC is on. So, It does display "Patch antenna not detected" when I power up the I2 but when I attach the patch antenna I continue to get the same message! I have restarted everything multiple times but still get "not detected" I had...

After a month away from flying (winter came back hard and strong), I was pleased to see all this Update News! I updated everything without issue but I have not tested yet. However, I do not see any indication on the Cendence regarding the patch antenna status. I have tried several times and...

I would imagine any heavy vibration is harmful. I haven't seen enough to concern me with the folding props on the inspire but over the long haul I suppose it's possible. I'd be interested in knowing what props where in use on the birds that experienced the failures.

I agree 100% with this practice! I cringe every time I see a video of someone changing modes while their bird is sitting on the ground. The footprint definitely narrows going into landing mode. Certainly there is a lot of torque going from the legs to the tube.

Here are a few shots showing the prop bushing and also shows the gap between the motor shaft and the top plate. The brass on the top plate screw location is only a washer, not a bushing.

As Michael said, the T-motor props have a captured nut on the bottom of the hub. I just installed mine this week after removing the Koptermax props. Much happier! I was not unhappy with the performance of the Helinengadin props but I feel the Tmotor props are a definite improvement. The...