Welcome Inspire Pilots!
Join our free DJI Inspire community today!
Sign up

Recent content by Ardi Wicaksono

  1. A

    Zenmuse Z3 - first photos and impressions

    Interesting ! specially for mapping / photogrammetry, do you recommend this or X5 for mapping over the X3? Does it blur a lot when you take photos while 3.5x zooming, while moving forward?
  2. A

    Battery Mod Info

    mine is 1.8.1 iirc, with turnigy 2 x 6s 2650mah 20c and TB48 with around 85% battery life(old battery with 50+ cycles) it hovered around 22 minutes,and light flying gave me 19 minutes to 30%.But i lost the green bar flight range calculation too,but there are flight minutes displayed on the dji...
  3. A

    Battery Mod Info

    Need help,is this solder job looks okay?it holds firm,and i secured it with hot glue after soldering.a bit nervous because im not an expert in electronics and diy job,h eheh. after i put the aux cable i measured the cable with tb48 battery on and it gives me reading 25 ish volt,just like the...
  4. A

    Battery Mod Info

    Uh oh...i accidentely shorted my tb47 balance board,by touching it with a metal tweezer,lesson learnt. Fortunately, that tb47 has almost reach its own lifespan (dropping to 3.3V when battery below 50%) Do you need to disconnect the balance lead before performing the aux cable soldering for...
  5. A

    Battery Mod Info

    Hi dammon i am prior to start my battery modification but i have a question. Looking at the pdf file on the first page you gave,do i have to solder the + and - aux cable a little bit below the blue marked lead (on my picture above) ? so these 2 are not connected. Or anybody else have a detailed...
  6. A

    Matrice 600 vs Inspire 1 Pro/Raw Industrial Use

    i mainly do inspection,surveying and mapping, using the inspire (with x3). I can tell you its perfectly fine,i flew a lot in highway construction site,construction sites and sometimes oilrig with no problem. I might ask what do YOU want to focus in the long road. Inspection only?then i probably...