Welcome Inspire Pilots!
Join our free DJI Inspire community today!
Sign up

Recent content by Arley Clark

  1. A

    Thinking of upgrading from Phantom Any thoughts?

    Excellent too, but expensive to fix.
  2. A

    Used I1 coming from B&H. What should I look for?

    Check the tightness of all the screws. I had some of them backing off on a used Inspire I purchased and actually lost one screw while flying that was holding the motor on. Noticed it on preflight that one of the motors was loose. Previous inspections, motor was tight. Lucky. Re-apply Loctite if...
  3. A

    Over tightened my props

    The mounting is different. If your motor outrunner is bad, you can replace with the E800 motor out runner, If the winding is bad, it is not going to work. You need to either do the winding yourself or send the whole thing back to DJI. There are people who use the parts from a new inspire and...
  4. A

    DJI Inspire 1 Parts For Sale

    I need the (Tail Light LED). Not the plastic cover but the LED/USB interface board under it. Also need the cable connecting too it.
  5. A

    Controller parts

    How bout the main board and ribbon cable going to the usb/hdmi board? Wait a min. is this for the inspire or phantom?
  6. A

    I think I received a defective unit.

    Looks like its getting packed back up tomorrow. Grrrrrrrr.
  7. A

    I think I received a defective unit.

    Just got my inspire today. Ran through all the updates and calibrations, went to start the motors and bingo, ESC failure, cannot launch. What a let down. Also have no light on the back of the right arm. This is not looking good. Im thinking its heading back to the vendor unless anyone has any...