Recent content by Bridion

Unfortunately there is no other way to connect I2 to PC, only with USB a to USB a cable. This one looks good Other way is to DIY using two USB cables, but if you are NOT familiar with such a mods DON’T do it!!! GND and 5V make a difference ?

Well, may be beter way will be not to talk to DJI support, but take the stuff back and get a professional technical expertisis in your country or only talk to DJI this way: „if you don’t agree with me, i will take the wreck to technical institute, to get know what realy happened and how only one...

Congratulations!!! Don’t care so much about the bird. I know that is a lot of money. But be happy with your son’s birth. But in the subject we discuss here. I am almoust sure there were no screws. That was the first thougt, I saw this two brand new holes. They should be a little bit dirty with...

Where are these two missing screws? Did you found them? I am afraid there were only to screws holding the motor!

You are absolutely right! I've made a small reverse engineering on Texas Instruments in ESC subject ;) Just for information, our ESC module should be build like DRV8301 BoosterPack! but at smaller scale. The main three elements are: TMS320F28027F Piccolo™ 32-bit MCU with 60 MHz, 64 KB Flash...

As I have already noticed, there is no way to retrieve any iformation from S/N number, so we can only compare software, not hardware. But hardware may be different from part to part of production. I will tell you why. The main differences in hardware may be in simple components used to build a...

Well, tell you how I did manage to downgrade to V01.01.0200. But it wasn't so easy. You've got to be careful, have battery fully charged. 1st step: DUMLRacer V1.1.1 to get root access. 2nd step: DUMLdore V3.10 to transfer and flash firmware. I had to do 2nd step twice, because after first pass...

Lucky you :-) But mine, during test flights seems OK either. I know that some firmware can't be downgrade. I do not want to change flight controller's parameters - max attitude, speed etc. I just want to check if there is hardware or software problem with FPV camera. That's a pity there is so...

Thanks for the info, but there is a problem in my case. Unfortunately I’ve bought I2 broken and without a gimbal camera. So even if sd card is in, it isn’t visible for Inspire - DJI Go 4 and in aircraft status there is an Air Encoder Error (0x100000) meaning that there is no camera atatched to...

pepeticos, Did you manage to roll back the firmware, because I have to roll back from .0100 and I can not. Just let me/us know

Hello, thanks you are asking. I2 worked for rskorbital.com from UK and was sold by eBay user. It has broken absorption board and a motor mount in płace of joining with carbon tube of right back arm. So I will have to change the arm and absorption board. But after a few days of happiness a FPV...

I bought a broken Inspire 2 and now I am repairing it. Today there was a first test flight But when I was repairing a broken motor basis, I discovered a stain on ESC module. Have a look, should I change it? There were no warning during flight. May be is some way to check it fuctionality?

I bought a broken Inspire 2 and now I am repairing it. Today there was a first flight This is a great aircraft. Recently I had Phantom 2. Greetings to all of you