Recent content by Charlie Dinge

Maybe a good follow up question is, since it appears that the craft just drifts off and the gimbal goes all wonky, is it something internal like the GPS or IMU unit? I feel like replacing all the motors wouldn't do anything. Up until this point, I had flown about 6 minutes without issue.

I think I have the same issue. Looks like this.

Here is a video of what its doing. Pretty extreme if you ask me.

Fresh blades does not seem to remedy the problem. I did downgrade the firmware which seems to have resolved the "boat on the water" issue. However, its still puzzling because when i go straight up after takeoff, the first 20 feet goes quick, but it almost seems to hit that height and then...

I am unable to notice any difference in temperature. I went out and flew around for a bit and it seems like the vertical speed is a lot slower than it used to be. I just went straight up off the ground and the initial 20 feet or so seemed fine, but past that, it seemed to slow way down. It...

I would say that if i physically spin the motor, there is no difference that I can hear. Only very briefly when throttling up when its on the ground.

Hello all, Ive done some basic searching but I wanted to discuss with some people who might have some ideas. While flying, I can physically see my Inspire swaying back and forth. At times, the entire craft will be tilted to the left or right. The video comes out like its sitting on the deck of...

Does it matter how you connect the wiring from the x4 to the DJI connector? In the DJI connector, there is the inside white wire and the outside "sheath" wire. What connects to black and what connects to red? Maybe im thinking to far into this.