Recent content by JFindley2

Sounds like you have a fit/clearance or a lubrication issue. The bearing should fit tight enough to resist any pull from the screw. There is no retainer on the screw side. The easiest fix, might be Loctite. Clean the bearing outer race and "socket" with acetone/alcohol first. In my experience...

Good evening. I do my own repairs. I spent a significant amount of time and money in parts to learn the in's and out's of repairing, just the Inspire 1. While there doesn't seem to be "acceptable data", modular replacement after troubleshooting, works pretty good. Had pretty remarkable results...

I've seen two mechanical issues, failed mechanical connection ("stripped") between the motor and screw, and a jammed screw. Both solved by replacing the center frame or motor. Sounds like the same symptom you described. Let me know if I can help. Can you hear the motor working? And to confirm...

Can you give some feedback about your experience with the I1 conversion? Was it useful to your customer(?), cost effective solution, data accurate? etc. Thanks in advance.