Recent content by Jonathan Abdoo

Is there any easy way to draw grid lines on a drone deploy map other than trying to manually do each one? Is there any app out there that I could take the drone deploy map and upload it and have it draw them for me? I mapped a piece of land but I need 4x10 grid lines drawn over the land.

As long as you fly responsibly and not too close to airport you will be OK. I don't think anyone expects you to spend a lot of time trying to contact every little airport. Just be mindful of your aircraft and surroundings and stay as far away from airports as possible.

I love the hoodman brand. They make a sun shield and a hood extender that is almost like FPV Goggles, but in a shield that you rest your face in. Look for hoodman shadow box and extended hood.

Very pretty photo!

When I first started flying my inspire it had a vertical speed of around 11-12 mph. I never noticed until today, but now it's only getting 6 to 7 mph. Anyone have any idea why? Also, when I take off full speed the aircraft doesn't seem to want to fly straight. This seems to be worse in...

Ok. I will try to run those Calibrations in an area with no interference and IMU on completely flat surface. I have done it on tile floor in my house and on top of dining room table but I don't know if they are completely level. Could a battery cause the bird to go nuts? I am about to...

Makes sense. I will try your suggestions. Thank you!

I did update the firmware but I dont think I removed the files from the SD card. I'm pretty sure they are still there. I am pretty sure I got all the batteries updated but I can double check that. I just did another IMU and compass calibration. The compass was reading 1340 or something like...

I have a couple of problems with my inspire 1. I have done a compass calibration and an IMU calibration, as well as an RC calibration. I noticed that when flying forward with the inspire it doesn't make a straight line. It seems to drift one way or another. Is this normal? Why would it do...