Recent content by LinusGrane

Does anybody know if the KopterMax props fits the xoar self-tightening adapters? I accidental busted my xoar... ?

aha, just needed a firmware upgrade ?

I have bought a dji focus controller for my x5r but its not working. I have plugged it in, turned on the AF but nothing is happening :/ any ideas?

But it is harmful to discharge more then 10 flights?

I know you should fully discharge the batterys every 10th times but can it be harmful if you do it to often? When i fly my inspire i often go down to 20% then recharge, so its easy to just hover a little bit more to go down to 10-0%, or is it better to charge when it 30-40%?

sounds good :) but is it the thrust washer even if the play is radial?

This is how it sounds, the first motor is the odd one fitted whit boca bearings, the other motors all sounds like the second. It would be good to know if someone who fitted their inspire whit boca bearings can check if it should sound that way.

Feels like the magnets are stronger in the ”odd” motor. Can it be a motor from a different batch?

Got the Boca bearings today, but it still sound different... The bearings is the only moving parts, and everything else in the motor is rock solid. Maybe i´m just paranoid...

How is the LiIon-pack working in low temp? Do you use the heater and patches?

Is it possible to make knockoff/aftermarket battery's four the inspire 1? And how about recelling old batterys? US $5.0 |ZDF 3.8V max 4.35V 2250mAh di Ricambio Lipo cellula di batteria di riparazione Della Batteria per Dji Inspire 1 TB47 Intelligente batteria|Componenti e accessori| - AliExpress

i used this bearing. Not the most expensive ones... I can feel a small radial play in the motor.

Hello, one of my motors sounds a bit more rough when i spin it. It also vibrates a little bit when i run it whiteout props. I have replaced the bearings but it still sounds the same. I didn't use boca bearings (i have ordered to all the motors but it takes 1 month to ship it to Sweden) so i dont...

Hello my name is Linus and i hav bought a used Inspire 1 Raw to use in my Film-projects.

Hello this is my first post here :) I have bought a used inspire 1 x5r but i think i have to replace the props. I have looked at the XOAR props whit the Aluminum Self Tightening Adapters. I have read good things about them in older post but i just wanna check if they still works fine :) Also...