Recent content by RossDrone

My boss did it without me so I didn't get to see it. There are a couple of videos on youtube of people replacing those connectors for the same reason and with his previous RC experience he was able to figure it out. It looks involved. If I had to do it without him I would have taken it to a...

It is fixed. When we took off the landing foot to replace it, the antenna was just hanging on the wire by a thread. (We had also ordered four new antennas.) When I tried to disconnect the antenna, it snapped off. We ordered those connectors and replaced the connector at the antenna end, but...

These are the connectors needed for this fix https://www.showmecables.com/mmcx-male-crimp-connector-lmr100-rg-174-rg-188-rg-316 https://www.showmecables.com/mmcx-right-angle-male-crimp-connector-rg-174-rg188-rg-316-lmr-100 We successfully used these and the drone is back in operation

Here's what I have found. I believe this is the connector in question MMCX Male Crimp Connector - LMR100, RG-174, RG-188 & RG-316 Now my question is what is the cable? I can't see any writing on it and I don't know the first thing about it. I looked up the four types listed in the...

Hmm, I thought I had figured out that it's an MMCX connector.

Hello. I ordered a new landing gear "foot" for my Inspire 2 along with some new antennas. When I went to replace it this morning I managed to break the connector that connects to the antenna. I've been reading for a couple hours now looking for this part but am unable to locate it. Various...