Recent content by Ruprect

UPDATE: Ok, I finally got my Ncore unit in the post and hooked her up. All looks good, firmware 1.8.1.40 cam firmware is already on the replacement unit, RC unit linked up straight away (wouldn't link with 19_00 error previously) so I think I'm back in the air with this baby. Lessons learned: OK...

hmm sounds like the compass error I had a while back... I was able to fix it by removing the nose cone and reseating the connectors that join the compass module to the Ncore unit. You refer to 1.06, I have never seen this version. The repository I use jumps from 1.04 to 1.08. If such firmware...

Will do, Module 19 (19 00 in the logs) appears to be a chip in the Ncore module. This is speculation based on the phantom product but people in that forum have had the same error. It is a chip related to image transmission and I seem to have made mine unhappy and cannot bring it back.

Yes I had successfully rolled back to 1.08 using an X5 (I don't own an X3). I then started getting in flight battery errors on a couple of my batteries (TB48). I then read that each battery needed to be rolled back also, I started doing 1.08 firmware updates with each battery installed. That's...

Ok so I seem to have bricked my inspire 1 (X5 Raw). As you can see in the log, I seem to have fried module 19 00 as the installed firmware just keeps showing ver 0.0.0.0 and refuses to update. Does anybody know what 19 is ?? Any suggestions appreciated Log follows: [00008829]========== remo-con...

Is the problem evident in both natural (sun) and electric light sources?.... 25 fps can get flickering in countries that run a 50Hz electric supply frequency

Check this out...... Posted a week ago, even shows Sydney Airport about a mile away (0:15), the whole video is within the NFZ and he/she puts their company name all over it. People familiar with Sydney will know Marrickville is directly under the glideslope for one of the runways! Are these...