Recent content by thecampilot

Flights using Drone Deploy don't appear in the flight logs anymore. Have I missed something? TIA

DJI charging hub for TB47 & TB48. 12 months old, excellent condition, surplus to requirements. UK only please. £45.00 including postage. This item does not include the standard charging lead.

Watty, sorry to have to say I bought a replacement from an Ebay user who had upgraded to an X5.

I upgraded the aircraft firmware to 1.9.1.30 on July 17th and flew with RC version 1.6 no trouble. My problems began when I upgraded the RCs 12 days later. I would stick with what you've got until you have firm confirmation that this issue has been resolved.

Simon, Thank you for this. Although I had to repeat the calibration several times I finally got the sticks working. I've been struggling with this for a week now, since I updated the firmware and it's no joke putting potential clients off. My camera operator found it very difficult to control...

Well, I've made some progress at last. I took Neil's advice and downgraded then reloaded with the master first. I still had no video signal or gimbal control on the slave. Next I hooked up to DJI chat again and watched DJI's tutorial for binding the RCs which involves entering the password for...

As a matter of interest, the DJI techie advised me to try the upgrades with an Apple rather than the Android. I connected the apple but the 'Equipment' screen displayed only the Phantom series although we'd only ever used it with the Inspire 1. Absolutely baffling and so frustrating. I had an...

Not sure where to find 'Linking Remote Controller'. I have downgraded the master back to the previous firmware then upgraded both again, mater then slave. My slave is now indicating that it is the slave and the Master RC number is displaying in the Master RC List, so I seem to be making some...

Still no success with the slave remote. On the Aircraft Status screen the Overall Status is blank. The LED is blue. Any more advice please?

The slave doesn't give me the option to downgrade. In the 'Remote Controller Settings' screen I have only Gimbal Speed, Stick Mode & Button Customisation.

Socrats, Lets hope a knowledgeable Inspire owner on this forum can bail us both out. My permission doesn't allow me to operate solo so I'm desperate for a solution.

I'm a little wary of flying when I'm not sure what's going on. I've started the motors up and the controls seem to be altering the motor speeds ok.

I went through this with DJI and made slave the master and master slave to no avail. Now I can't get the option on the controller settings screen, it simply reads 'Disconnected' The 'About' screen for the Master reads as follows: App: 2.8.3, Version: 1.9.1.30, Camera: 1.8.1.00, RC: 1.7.40...

This morning I updated to version 1.7.40 on my remotes and lost use of the slave controller. After 2 hours of going around in circles on DJI chat I'm no wiser. I was advised to downgrade the controllers to 1.6 but having done this the master displayed only the Phantoms and I have the inspire 1...

I'm not sure this is the same issue but I had trouble setting up my second control as the slave. The problem was with the device which is a Samsung. I went into Settings, System, Developer Options, and enabled USB debugging. If you are using a different device from your original successful...