2mm allen screws?

[lrwskyfilms]

Hello, the Inspire is flying great, however I've just noticed that nearly all the 2mm allen screws on the arms and legs, that's 8 in the middle of each arm where they meet the legs, and 6 on each of the four legs, all of these need an adjustment of at least 1/4 of a turn to tighten them. Is there a problem if I do this? Many thanks, Mark

 

[DroneTech]

You should not have any problem. Just be sure not to over-tighten.

 

[lrwskyfilms]

Thx for the reply.

 

[The Editor]

Are they threadlocked? If not, do you think they have 'worked loose' or do you think they have been like it from delivery?

 

[lrwskyfilms]

Are they threadlocked? If not, do you think they have 'worked loose' or do you think they have been like it from delivery?

Hi, threadlocked? Not really sure what you mean.
Could off work loose and/or been delivered like it, I've been flying a quite a few times and always raise and lower the legs a few times each flight.

 

[DroneTech]

Yes, they are threadlocked (blue)

 

[lrwskyfilms]

Ok thx for the info.