Hi guys,
I've read a lot of your posts about the problems with not working rc... but I think my situation is different.
Apparently without any firmware updating process... my master rc did not receive the signal from the DJI GO App... only the slave rc. The strange thing was that if I change the slave setting to master I would loose the communication through usb.
The master rc controls the Inspire but not receives any data from the usb. I think it is not a broken usb port because if I set the slave to master it does the same.
The problem is that now I tried to reset the slave with the 3 buttons push but....now it is not paired and to regain the gimbal(and video) control it asks me the password... which password?
I've read a lot of your posts about the problems with not working rc... but I think my situation is different.
Apparently without any firmware updating process... my master rc did not receive the signal from the DJI GO App... only the slave rc. The strange thing was that if I change the slave setting to master I would loose the communication through usb.
The master rc controls the Inspire but not receives any data from the usb. I think it is not a broken usb port because if I set the slave to master it does the same.
The problem is that now I tried to reset the slave with the 3 buttons push but....now it is not paired and to regain the gimbal(and video) control it asks me the password... which password?
