Hello guys!
After years of flying without problem, My Inspire 1 v1 with X3 is dead after upgrade.
a) RC control connect to AC (green status led is ok)
b) DJI Go app with "IMU Error. Calibrate IMU"
c) Sensors state is missing - it is not possible to calibrate IMU
d) Status Led flash: red .. green .. yellow .. blue continuously
Aircraft Status:
IMU Normal, Coampass Normal, Radio Channel Quality Poor
About :
App 3.1.23, Version 1.2.0.12, RC 1.7.80, Flight Controller SN is empty
Some images from the DJI Go screens are attached.
I appreciate any help!
Regards
DJI Go Screens:
After years of flying without problem, My Inspire 1 v1 with X3 is dead after upgrade.
a) RC control connect to AC (green status led is ok)
b) DJI Go app with "IMU Error. Calibrate IMU"
c) Sensors state is missing - it is not possible to calibrate IMU
d) Status Led flash: red .. green .. yellow .. blue continuously
Aircraft Status:
IMU Normal, Coampass Normal, Radio Channel Quality Poor
About :
App 3.1.23, Version 1.2.0.12, RC 1.7.80, Flight Controller SN is empty
Some images from the DJI Go screens are attached.
I appreciate any help!
Regards
DJI Go Screens:
