Quick release props Question

[imaspireFR]

Hello, this is my first commercial RTF.
I have just received my I2, she is new.
I am very surprise by the "floating" "gap" between the Quick release props and the motors ?!!?!!? It is about 0,25 - 0,5mm
To compare with my DIY hexa, my Xoar props are very screw with my T-Motor with nuts.

Do you get same "floating" "gap", is not normal ? Thanks for your answer guys

 

[Casey53]

I did the CA glue (Medium thickness grade.) to the underside base of the loose props and set them aside for a day. They fit snug after that.

You could send them back to DJI after getting a RMA and all that waiting stuff too. Fwiw, my bag of props had old as well as new versions intermixed (V1 and V2 props, but some still needed the glue on the underside.).

 

[imaspireFR]

Thanks you very this helpful hints !
I will do it very quickly !