Sorry another firmware question !

[David Herman]

I have looked everywhere for this answer here, sure I saw it once so apologies if repeating.

I upgraded from v1.8.1.00 to v1.9.1.30 no problems, rc asked and updated ok, did IMU all works fine but status screen on app is blank I'm on IOS and latest DJI Go app, any advice would be helpful, cheers

 

[The Editor]

I have looked everywhere for this answer here, sure I saw it once so apologies if repeating.

I upgraded from v1.8.1.00 to v1.9.1.30 no problems, rc asked and updated ok, did IMU all works fine but status screen on app is blank I'm on IOS and latest DJI Go app, any advice would be helpful, cheers

Give it time to compare your firmware version to that held on DJI servers.
It will eventually update when your tablet is connected to the Internet and your Inspire and remote are powered up.
It can take a few minutes

 

[David Herman]

OK my bad..........I think? I thought you had to go to overall status to get versions, sure I read that in the manual, but no, go to the three dots in corner of main screen and down to about, there it was all updated nicely !!!!