Wanted - DJI Inspire 1 Remote HDMI PCB

[Ewan Morrish]

Hi Everyone,

Just chasing a replacement HDMI daughter board for my Inspire 1 Remote. The USB/HDMI module underneath the remote is made up of 2 PCB's. The main PCB has the USB attachments, and ribbon cabbles from the main controller, but the HDMI module sits ontop of the main PCB, and in my second remote this smaller PCB has gone faulty. I was wondering if someone had replaced the whole USB/HDMI module with the Phantom 3 HDMI upgrade kit, due to an issue with the USB/Main PCB, but they still had the working HDMI PCB they might be willing to sell. I'm trying to not have to replace the whole setup, and just replace the smaller faulty component.

Thanks in advance.

Regards,

Ewan.

 

[The Editor]

Answered you on your other thread - The P3 'Upgrade' board will work on the Inspire Remote.

Let me know if you are going that route and I will close this thread.

 

[Ewan Morrish]

Thanks heaps for that. Yes i'm going that Route. You can close the thread.

 

[The Editor]

Thread now closed