Hello,
I recently purchased Xoar carbon fiber folding props for my inspire 1 pro. After I attached the props and adapters, I realized they hit the top of my x5 gimbal mount. I verified that I correctly followed the instructions provided with the props, but after looking at pictures of the inspire 1 shown on their page, I realized the 3510H motors did not have the center screw. I can see how the addition of the screw could cause the props to hit the gimbal mount, but there was not anything stating to remove it. Does anyone have any insight on this matter? And if I am supposed to remove the center screw, could you please explain how to do so?
Thanks in advance!
Best Regards,
Ro
I recently purchased Xoar carbon fiber folding props for my inspire 1 pro. After I attached the props and adapters, I realized they hit the top of my x5 gimbal mount. I verified that I correctly followed the instructions provided with the props, but after looking at pictures of the inspire 1 shown on their page, I realized the 3510H motors did not have the center screw. I can see how the addition of the screw could cause the props to hit the gimbal mount, but there was not anything stating to remove it. Does anyone have any insight on this matter? And if I am supposed to remove the center screw, could you please explain how to do so?
Thanks in advance!
Best Regards,
Ro