Recent content by ESC21

I did two remote controllers yesterday. Unzip BIN file, put that on a empty USB. Turn off remote. Put USB in. Turn remote on. Leave for 20 sec and it will start with a blue led . . . . Leave for 4 min and LED turns green - thats it. Hope this helps. /ESC

Hi Editor. Thx. I just wanted an old BIN file to see if the inspire would "eat" it.. My inspire is messed up and wont take the new firmware.. everything else is upgradet. Im stuck : -(

Hey guys. Does anyone have an old version of firmware? I have major issues installing the new one. THX. /Kristian.

Does anyone have an older firmware I can try? just to see if that can be uploadet to the inspire?

It is just standing like this one in the movie.. No beeps, just RED LED and scratching.. It is not reading the firmwear file in the right way.. or something.. : -(

========== 2014.01.01 00:00:10 unsynchronized ====== Packet: WM610_FW_V01.02.01.03.bin Result: Failed. Reboot the aircraft and try to upgrade the firmware again.

All right guys.. Ill format card and get a "new" version of the firmware... Gives me a chance to check the TXT again :-D BRB

Hi Rilot. I did try that earlier today.... I think the update was not complete the before I turned the copter off and now it is just messed up and cant read the file. But Thx mate : -D

Hi Steve. No beeps... When I power it on (with the SDcard in camera) it just starts in full red and no beeps at all. I can here the card is reading/writing otherwise nothing.. I have check the TXT 5 times today.. just failure failure failure.. I did upgrade my two new RC`s, that went fine.. My...

batteri down to 50%

Its been standing like this for almost 2 hours now

This thing will never fly.. I just got the Inspire yesterday - I have never been flying with it and the firmware upgrade killed it. Jesus.. 3000 dollars out the window.

Mine is the same!! Just red and same noise... Im not sure it will work.. im waiting...... and waiting...