Recent content by Håkan22

What versions (app and FW) did you experience this with? And when did you last upgrade you app and FW?

HOLY COW! I spent several hours and it was just that.. Learning as long as flying DJI. THANKS!

Upgrade app to latest and checking all OK, all was fine. When restarting the craft a second time the gimbal start initialize and comes around at first but then just hanging there. At the same time image transmission lost. See video. Tried: - Another X3 which is working. Stop at the same...

Ok. Thanks for the tip. I think i will out tomorrow and check out how it works in the air too. Done that GO update and need to check out so that all is OK anyway. That is if I manage to get out before it's getting dark which happens sooner than later this time of the year..

Purchased a can of WD-40 SPECIALIST too. Just gave my Inspire a taste of it and it appears the landing gear runs much smoother. It might have been my old grease was more or less gone.

If your RC is at version 1.3.00 or later you need to update the RC using the app. So while having the bird shutdown, start up the RC and your device. Make sure you have the latest GO app and make sure your device is hooked up to wifi. When you start the app up it will tell you the RC needs an...

I think I will raise an request for enhancement to have at least the transmission rate to be altered..

European Union. If going to that page the custom option is grayed out over here. I think it has to do with CEE vs FCC ( I hope I got those abbreviations correctly)

Pity that function is completely disabled in EU ....

After installing the updated app my map showed up again. It could have been the updated app or the "reinstall" that made the trick. I have seen others having the same problem solved by reinstalling the app.

I went for it. I haven't flown it yet but good things were, the map showed up again. Bad things. App crashed one time bringing´it up. "Disconnected" happened while working through the settings and aiming the motors (without props) Connected after shutting down motors. Tried a couple of times...

Showed up after updating to latest GO app..

is it maybe due to me using the GO app version next to the latest? Still reluctant to update although I'm running the latest FW .. And "she" says homepoint set, check it on the map.

Seeing all kind of issues with all kind of firmaware and GO / Go4 updates... I have an Inspire 1 V1 with the latest FW. My GO app is the version before the latest. Can I expect issues updating it?

I can't find any instructions on how to calibrate VPS on an Inspire 1. Only possible on Inspire 2?