Upgrade app to latest and checking all OK, all was fine. When restarting the craft a second time the gimbal start initialize and comes around at first but then just hanging there. At the same time image transmission lost. See video.
Tried:
- Another X3 which is working. Stop at the same place. (X3 and gimbal OK)
- Checked the connectors > gimbal on the craft. All good.
- Checked the connectors between craft > gimbal mount all OK as far as I can tell. dismounted the card from the craft and the 2 cables.
Before I send it to DJI, anything else to check?
Thanks!
Tried:
- Another X3 which is working. Stop at the same place. (X3 and gimbal OK)
- Checked the connectors > gimbal on the craft. All good.
- Checked the connectors between craft > gimbal mount all OK as far as I can tell. dismounted the card from the craft and the 2 cables.
Before I send it to DJI, anything else to check?
Thanks!