Recent content by mmoguls

Stay away from trees. They are not your friends!

Overall I really like the controller except for the weight. The only problem I have is the fact that gimbal button functions change between DJI go 4 and DJI pilot. I like it set up to revert to forward view, only works in Go4

You can also use DJI Pilot, but it is rudimentary.

Absolutely

LOL Really, no idea? Bucks my friend, greenbacks, benjamins,

Drones made easy. But it's only available for the iPad, can't use the Crystal sky for it. That's why I have two controllers

Most of the symptoms that you are talking about are usually caused by a minor crash. It sounds like it's time to send it back to DJI for service. Don't risk your cameras by trying to fly it until it's been thoroughly checked over.

I purchased a version1 in December 2019 on eBay. It had been flown three times and included a high-end gpc case, 6 batteries, X4s camera, cendence controller, Crystal sky monitor, shock absorbing landing gear, cendance antenna, chargers, hubs. Top mount and dual lower gimbal mounts. This was...

Thanks, there turned out to be several modifications made to this drone's firmware, causing a crash (no camera attached at that time.) I since replaced it with a M100 from the Mythbusters inventory. It had only been flown 4 times. Now adding guidance to it, cameras to come. Thanks for your...

it's a terrific case and holds virtually everything you could want to carry with the exception of the shock absorber landing gear. if you're going to send it back because you have to remove the landing gear then it's wasting your time to buy it because you will have to. The more batteries and...

In fact all inspire ones have the ability to use threaded props. All you do is remove the QR adapters and you are set to go again.

If you are shooting in raw the output will look dull until you enhance it in post.

I'm attempting to get my newly acquired M100 to work with my known quantity Zenmuse 30 camera. This Matrice was doing the constant Beep Beep Beeping, and I used my old X-3 camera to reinstall firmware version 01.09.01.40 and this stopped the racket, and it restarted and shows telemetry now. I...

To anyone concerned about the original prop situations for version to the answer is very simple. Remove the quick-release mounts and use the original spin on type mounts that are still widely available.

I may have one for sale soon, get back to me next week please.