Recent content by pallol

Does anyone know the operating voltage of the landing gear servo? My servo tester only operates at 4-6v and doesn’t move the servo, it only clicks slightly. The landing gear frame was swapped out of an inspire due to a bent screw. Yes the servo does work and was working when it was swapped out.

If your having problems rolling back your firmware, make sure you have a blank file named WM610_FW_DEBUG on your sd card. It’s needed to roll back from 1.11.01.50

That’s the results log found in the root of the sd card, it doesn’t give that much info apart from successful flash or not. the one I posted was the one in the hidden directory on the card. I just bit the bullet and did a downgrade to 1.09.xx, interestingly the camera also did a downgrade, but...

I use the SD card method and force the update with a debug file on card. As far as I'm aware, the upgrade finishes successfully, but the camera firmware stays the same. log file attached, its the only one on the card [00007103]Delete history success. [00007410]========== remo-con...

been flying with one of those for some time now with no issues. I bought the 6A block and calibrated it twice so far, it turned out to settle at 5.3A capacity, 400ma less than what I wanted it at, but still better than a tb47. when you get these things installed in the battery case, charge it...

Hi all, im having issues updating my x3 firmware. I had to replace my x3 after a bad crash, bent gimbal smashed case, but the replacement I got had a firmware version of 1.10.x.x whereas the original was the same as the bird 1.11.01.50. no matter how many times I reflash the firmware, the...

I suspect the issue may be a protocol one because of the new M1 cpu this iPad is sporting. that, and the USB port, is the only thing that’s changed, and since the iPad registers the connection to the rc (ping sound when rc turned on) it’s more likely an issue with the cpu.

Same issue here, inspire1 RC won’t connect to shiny new iPad Pro 3rd gen 11” and to top it off, it won’t connect to the iPhone 13 pro either considering the lightning connector on my iPad Pro 10.5” is shot, I have no vision and telemetry to fly with. I am, for the most part, grounded. not...

Marvellous how much video feed, distance and wifi interference improves when you turn off the wifi on the iPad. ?

not happy with the video feed, seems to start breaking up at around 900m or so, sometimes less, and my radio signal goes from great to poor with no inbetween at that distance (not every time, but roughly in the same area) to be fair, I have a lot of interference around here, but my mavic air 2...

Successfully downgraded inspire1 v2 from 1.11.01.50+ to 1.08.00 and rc from 1.7.80 to 1.6 using the debug file method. However, on Startup, the gimbal goes through the motions and then goes floppy and will not respond to movement or commands, but the camera itself still works. Going back to...