Welcome Inspire Pilots!
Join our free DJI Inspire community today!
Sign up

Recent content by Roconnor

  1. Roconnor

    Question on Advanced Settings for X5S

    Thanks for the links. Basically I'm looking for a detailed explanation of of the advanced gimbal settings for Pitch, Yaw, EXP, Smoothness, etc.
  2. Roconnor

    Question on Advanced Settings for X5S

    After reading the manual I cannot find any explanation of advanced settings for +EXP, Smoothness, Pitch/Yaw speeds etc. Is there an article on this? I spent about an hour looking for this info and cant find it. I'm also looking for recommended gimbal settings for speeds to give a "cinema like"...
  3. Roconnor

    Panasonic 45-175 mm lens for inspections

    Make sure you get the 5.6 aperture version, used $150, new $230 or so. If you plan to do power lines, EMI is a thing and the 100 CAN do it, but the 175 is obviously better suited for that job. I just cant get the X5S to do it in a way I feel comfortable. I know other guys do it, I just think its...
  4. Roconnor

    Panasonic 45-175 mm lens for inspections

    I just returned my 45-175... I don't know the major differences between the gimbal for X5 and X5S, but even when balanced perfectly I noticed a slight vibration, humming, and 6-8 degree higher temp (used a laser temp gun) on the gimbal with the 45-175. 35-100 does the job for the most part I...
  5. Roconnor

    No Status Light (green)

    Anyone have an issue where the x5 status light stops working, but everything else works just fine? Was wondering if it was a possible setting to toggle. Hoping its not a burned out LED.
  6. Roconnor

    Good fixed carbon blades?

    I1
  7. Roconnor

    Gimbal\Camera Settings

    I'm sure this will open much debate, I however was wondering if anyone had suggested settings for Gimbal for a smooth picture that is not too jerky. An issue I have right now is when I turn the drone, the camera has a really slow response on my horizon line going back to 0 (center). I'm sure...
  8. Roconnor

    X5 Gimbal Calibration Question.

    Thanks Simon. That's what I thought was the case. I have a penny on the pitch axis that now has my roll fairly balanced. One other question while on the topic, I notice when I make a turn/bank the horizon takes a good 10-15 seconds to level back out. Is that normal?
  9. Roconnor

    X5 Gimbal Calibration Question.

    Is there a way to physically calibrate the gimbals without taping pennies to it? I have a X5 that sags to the right on roll axis. If I counter balance it with a penny taped on, its fine. However, I was wondering if there was a way to physically adjust the gimbal so its weighted correct via the...
  10. Roconnor

    Motor overloaded warning?

    As a follow-up, this is NOT an issue with Litchi. The DJI GO app seems to have major issues with this warning. I flew for 30 mins today without any issues on Litchi. I swapped to DJI GO and nothing but wireless signal errors and motor errors. Aircraft performed just fine.
  11. Roconnor

    Motor overloaded warning?

    had an error today about a prop motor overloading. Anyone have this issue? What could be cause?
  12. Roconnor

    Good fixed carbon blades?

    What’s a good set of blades with adapters? I had a prop come off on takeoff caused a small crash. Heard the carbon self tightening blades may prevent this.