Recent content by stephen ceen

Thanks. Do you have any tips on removing the FC unit. Is it the black box in the front under the nosecone.?

I had a hardt crash and I am getting accelerometer errors. Can anyone tell me where the accelerometer on the inspire is located. According to some phantom owners one can tap to reset. I am also wondering if it is replaceable.

I don't appreciate being told to take a breath as it carries a very condescending tone. I am an African drone pilot with limited funds and a currency in free fall and the difference between purchasing the Osmo with or without a camera is a deal breaker for me. It is very easy to sit in the...

I would suggest that no one buys the osmo until they make it available without the camera. I purchased the Inspire after they first announced the hand held gimbal as I knew the X3 camera would serve a dual purpose. To have to purchase another camera at this point is disrespectful to all of us...

This happened to me the first few times I flew. After updating the firmware it stopped happening.

I don't see many dangers to this shot providing everyone keeps their distance and no one stumbles into the inspire. It is a open space with just crew and actors. They might also have a Ronin shot but they specifically want the overhead diagonal passes sweeping across the landscape and actors.

Below is what I have come up with...any comments/additions are welcome. I also have taken note regarding my responsibility for risk assessment and precautions. RPA(Remotely Piloted Aircraft) On Set Rules The RPA presents a potential danger to the crew for the following reasons: · Signal...

Thanks for the great advice. The project is a low budget fantasy feature set on a remote farm in South Africa. The set is closed with just crew and cast. The director wants diagonal passes over the actors as they trudge up a mountain,. The reference given me are some of the aerial shots in...

Can anyone suggest a safety briefing or rules to apply when using a multirotor on a film set. i want something to give to the crew to educate them about the potential dangers as well as a set of rules that will apply when the multirotor is in use. For example establishing a perimeter around...

I purchased a polariser filter from a third party manufacturer which fits the camera perfectly. it is however quite a bit heavier(8g) and causes the gimbal to flop straight down when the inspire is off. It seems to pick it up just fine when on and maintains a stable image but I am wondering if...

Regardless of DJI's motivations they have promised waypoints as a feature for the inspire. They talked about it around the launch as though it was already implemented and then backtracked and promised it later. This is a major issue for me as I purchased the Inspire with this feature in mind...