Inspire 2 Zenmuse X7 Error with new firmware (01.02.0400)

AndrewLapidus · Sep 25, 2019

Hello everybody!
I bought Inspire 2 with Zenmuse X7 camera, Crystalsky and Cendence controller. Drone was activated few days later and hasn’t fly. Image on monitor from X7 camera was good , but after updating firmware on last version (V.01.02.0400) I had critical errors (photo included) and no image from camera X7 on motior. I updated drone with my PC with cable from DJI Assist 2. But update was not correct I think . And I can’t downgrade firmware ... what should I do ?

P.s: x7 camera working with other Inspires 2 ( with latest firmwares) but not in mine... problem in my Inspire 2 updating I think...

Neeeed help

((

VideoGiuseppe · Sep 26, 2019

Probably the problem is related to the Vibration Absorbing Board that has to be replaced.
Many of us are suffering this problem.
I had this "Aircraft encoder error (0x400000)" last week, and I needed to send the Inspire to DJI to have it replaced

AndrewLapidus · Sep 26, 2019

VideoGiuseppe said:
Probably the problem is related to the Vibration Absorbing Board that has to be replaced.
Many of us are suffering this problem.
I had this "Aircraft encoder error (0x400000)" last week, and I needed to send the Inspire to DJI to have it replaced

I have opportunity to replace Vibration Absorbing Board in my DJI service center in my town but I think this is system or firmware error . Drone no one fly , and error was after updating , from old firmware X7 camera works good without errors.

AndrewLapidus · Sep 26, 2019

VideoGiuseppe said:
Probably the problem is related to the Vibration Absorbing Board that has to be replaced.
Many of us are suffering this problem.
I had this "Aircraft encoder error (0x400000)" last week, and I needed to send the Inspire to DJI to have it replaced

Have you got 01.02.0400 firmware? And how can I downgrade firmware ? Thank you