I installed the motors and updated the firmware. When i do the motor RC stick command to start them, from the manual, they don't start. I am not using the pilot app, has this happen to you guys?
I installed the motors and updated the firmware. When i do the motor RC stick command to start them, from the manual, they don't start. I am not using the pilot app, has this happen to you guys?
It can but how will you get your telemetry data or calibrate the compass (although that can be done manually) or check your mod values?
I think you need to do some reading before going airborne!
It can but how will you get your telemetry data or calibrate the compass (although that can be done manually) or check your mod values?
I think you need to do some reading before going airborne!
Hi guys, new to the forums. So my issue is every time I take my m100 off, after a few minutes, motor 3 fails. No bueno for flying obviously. I'm getting the obstructed motor error after it fails. Nothing in the props way, I've already replaced the ESC and motor. Any ideas why this is occurring?