XT Gimbal overloaded on 2 DIFFERENT XTs

[licensed pilot]

Started getting this message on one XT, Switched, both XT's give the same message and disconnect after about 15 mins flight.
X5, Z3 work fine on I1P. Any thoughts?

 

[The Editor]

Started getting this message on one XT, Switched, both XT's give the same message and disconnect after about 15 mins flight.
X5, Z3 work fine on I1P. Any thoughts?

Presumably you have tried gimbal calibration?

 

[licensed pilot]

Presumably you have tried gimbal calibration?

No sir...but that's why you are here. Thanks, Ill try that.

 

[licensed pilot]

No sir...but that's why you are here. Thanks, Ill try that.

Did gimbal calibration on both XTs, same problem. No issues on the M600P..gotta be the I1P, it is 5 years old...

 

[Donnie Frank]

Did gimbal calibration on both XTs, same problem. No issues on the M600P..gotta be the I1P, it is 5 years old...

Interesting problem. I would examine how much current the XT draws compared to the X3 or X5. I have a feeling that the XT camera may pull a little more current. If it does, as you suggested, a worn controller MAY be the culprit. I would also examine the contacts. The possibility exists that not all of your cameras use the same contacts. The only real way to examine them is to take a nice, big, fat macro photo. You should do that for both the Inspire AND the camera contacts and post your photos here.

D