Recent content by 60Cents

I have 3 inspire 1"s, 2 inspire 1 V2, and 1 inspire 1, V1. I also have 4 GL658 controllers, one A, one B, and two C's. I've replaced the HDMI board on two of them. I've flown the 1, V1 before with the A controller. However, now I can't get any Controllers to be recognized by my cell phones or...

I just bought the v2 goggles and the motion controller 2 to fly my mini 3 pro. I have 2 inspires that have been sitting in my closet for a few years; 1 pro + 1 v2 pro. Can I or how do I connect to one or both drones???

I popped the cover off and removed the balancing connection. That stopped the flashing.

I haven't tried that, Steve. I'll let you know how that works. I just tried plugging it in again and now I have a red light on the switch that won't go off with a single flashing light at the bottom. My multitester says it is at .944 volts. And nothing I can do will turn the lights off.

I have a TB47D battery that shows only one light flashing. I've seen a video that shows how to charge a low voltage battery with a balance charger. But I suspect that I would need to disconnect the balancing plug on the battery to get it to charge with a balance charger. One of the videos I...

Thanks guys I found the firmware I needed. Not sure where I heard that DJI was dropping consumer drones but that appears to be the case. finding batteries now is difficult

It looks like DJI has dropped the Inspire 1 from its web page. I understood they were dropping their consumer products but I didn't think they would drop firmware upgrades. Does anyone know where I can find the latest upgrade? It is a little disgusting that DJI would sell these products and...