Recent content by Dennis Muldrew

Yes I have tried that also.

Except that it happens if I remove the USB cable on the controller and replace it with a number of other USB cables. And it occurs also on the Cendence remote with a different CS monitor that doesn’t use a USB cable. I’ll check on the firmware for the CS sky monitor again

What else would you like pics of? The last pic is a view from my phone connected iPhone the remote.

I’ll work on that in a bit. Gotta attend to a pork butt. But to answer your question I did all updates required today.

There is no “Connected” banner at the top left of the screen. It says disconnected. But green light is on on the I2 and the remote. I can start and stop the motors and move the camera gimbal.

Strange it’s both cameras, not just one. Is there a camera mode it must be in?

R Reset CS, emptied cache on Go4, nothing. I just don't understand how storing it for 6 weeks would affect anything

Not the same cable. The standard remote came with an attached cable, so that's what I use. The Cendence doesn't use a cable, as its a pass thru situation from the receiver to the monitor. But you can hook a USB cable from the remote to the monitor also, and that doesn't work either.

I got a new Inspire 2 a few months ago. A Cendence remote and 2 Crystal Sky monitors. After I finally7 got everything in my order it all worked. I work in a hospital, with the Covid 19 thing we got pretty busy. I put it all in a case and did my thing at work. So today is nice, got a pork butt on...

Yes the X5S, and yes its a 46mm filter. I just can't get my fingers between the lens hood and the balance ring so I can take it off and install the filter.

How does the hood come off, just twist?

New I2 and X5S camera. On all of my digital camera lenses (Nikon) I’ve used a filter to protect the lens element. I’d like to do that with the X5S lens. I can’t figure out how to get it on the camera. Does the lens hood come off. Do I need to remove the balance ring? Thanks in advance.

:confused:Solved the problem tho...

Inside the battery compartment of my Cendence remote itsays Type GL900A. On this page Cendence Remote under specifications it shows GL 900A as the remote for the Matrix. So I believe I have the wrong remote, I think this is the new model. And then there is this!!!

Yes I will check. It’s what they sent me with the bundle. Do you know what the correct model # is for the I2?