Recent content by jaycmc

Yeah, I would agree it is the ribbon cable. Your video looks exactly like the problem I had before. I had accidentally stretched the ribbon cable on the foam in the X5 case while putting it in. There was a visible stretch mark on the cable. Sent it to dji to repair and cut some of the case foam...

I think it’s the hdmi output module being faulty on both remote controllers. Since you say you tried/have a working phantom 3 controller I would swap the hdmi module from the p3 controller onto one of the inspire 1 controllers and see if it works. (The hdmi output module for p3 and Inspire1...

Did you try updating the Inspire’s firmware? I know from experience if the drone’s firmware is older than the remote controller’s they won’t connect, and usually means the drone is stuck in travel mode (blue flashing light) and won’t update. If that’s not the problem what message are you...

It’s just a replacement gimbal port you need. Around $30 usd from flea bay new. Lowest is $25 right now when I checked.

I think they are. You can load Pro X5 firmware on an Inspire 1 and vice versa depending on what camera you are using. Also firmware doesn’t matter if V1 or V2. The only physical difference I have seen in ncores, I don’t know which models they came from, are different color fan wires - red and...

Another option is to get a used n-core out of a crashed Inspire and swap out with yours. It will be more likely a newer firmware than yours and it will work with your RC.

If the Centre frame is not damaged then the most common cause is the RC firmware is newer than the aircraft firmware and the versions are incompatible. There’s a lot of threads on this. You can try to downgrade your RC firmware and see if that works. Or what I have found works best is to find...

The panasonic SFC0190 should fit. DJI lens is a Leica H-X015 Summilux lens copy. I have the same problem and have 1 on the way. I’m in Australia so taking a while...