Recent content by Origami

for sure I would never trust these transplanted batteries as they are now, most likely just going to be a very short flight and over flat ground and low attitude. I saw your videos and may be interested in getting a test run of the programmer to reset the head and set the proper values.

Disclaimer: Do so at your own risk, li-ion packs are very explosive and dangerous if not handled correctly. You will need a proper soldering iron, skills and a basic understanding of electricity/batteries to complete this swap. I have bought 2x of the "TB48" cell packs from the aliexpress...

That is indeed amazing that there are still brand new TB48 being made. Have you asked if they still have those in stock and ready to sell in Korea store?

so a little update, I purchased a replacement cell from HSABAT and tried to replace my stock TB47, upon powering on the led showing low batt (1 flashing green) but it does power on the aircraft. the app shows all 6 cells @ 4.00V, pack at 24V with 0% battery remaining and 0mha remaining. Now the...

the Koptermax seems promising! I will check them out.

doesn't the smart board need to be reset for replacing the cells? I believe the ones I have are all showing damaged in the app not sure if that will cause any issues.

Hey guys, just got an Inspire 1 v1 from a friend but unfortunately, both of the TB47s are completely dead as they sat in his garage for years. I'm trying to source some new batteries but looks like everything is old stock and over $500 cad online. Since DJI no longer sells these, are there any...

try replacing the HDMI board that sits on top of the USB board.

late reply but I have the same issue with one of my remote control, turns out to be a dead HDMI board. I swapped the working HDMI board from the working remote to the broken remote and the USB started working right away and I was able to update the firmware on the broken remote. So far I...