Welcome Inspire Pilots!
Join our free DJI Inspire community today!
Sign up

Recent content by Shadowoh

  1. S

    Gimbal roll reached end postion

    I didnt even touch roll axis magnetic screw. Yaw axis was 100% set correctly, cause it was marked and I did 6 flex cables replacement, so lets say I am a bit experienced user
  2. S

    Gimbal roll reached end postion

    Ok, I will check it, but dont You think its because mother boards swap? They look the same, but maybe I need to do some adjustments?
  3. S

    Gimbal roll reached end postion

    Video
  4. S

    Gimbal roll reached end postion

    Hi. After flex cable and mainboard replacement my gimbal is dead. Have vision, autofocus, but gimbal wont calibrate or anything. Just saying "gimbal roll reached end position" and its over. No calibration, no moves, no controll. :/ I did fw update. Didnt help. Any ideas?
  5. S

    Inspire Pro another issue

    Just took it out and then installed again... Magic... :D
  6. S

    Inspire Pro another issue

    Solved. Replaced flex cable. No effect... Reinstalled SD card... Camera is fully working... Please kill me! OMFG
  7. S

    Inspire Pro another issue

    Hi. As you can see in the video linked below my camera/drone suddenly stopped working properly again. Do You think flex cable could get damaged again or its drone fault now? Is it normal that drone (inspire pro) is being recognised as inspire one in app? Drone is flying normal, i can use gimbal...
  8. S

    Laowa 7.5 light + x5

    Do You have standard or light version?
  9. S

    Laowa 7.5 light + x5

    Ok, but I saw somewhere it is not locking properly on x5 (it is like portrait mode?) and locking normally on x5s. Is that true? Causing further problems like vinetting? Cropping? Anything?
  10. S

    Laowa 7.5 light + x5

    🤣 "Hot swap" is a must? Or they can be used as other lenses
  11. S

    Laowa 7.5 light + x5

    How about new version with automatic aperture?
  12. S

    Laowa 7.5 light + x5

    Hi. Anyone tried that setup? Inspire pro + x5 + laowa 7.5mm light :) ?
  13. S

    X5 problem

    Flex cable / ribbon cable
  14. S

    X5 problem

    Hmm... there are 2 cables near gimbal mount (drone side) - 10-pin and 8-pin cables. So there should be working 18 out of total 20 pins
  15. S

    X5 problem

    Yup. Still these 3 that seems damaged could be used maybe with x5R? Or even x3? Who knows... When i get another flex I will do the same test and will compare both