Recent content by Thomas

Same exact thing happened to me two weeks ago. First fly-away after 98+ flights, took off, within seconds saw a message pop up, "Update..." then it took off on its own. Only by pure luck it didn't crash into any of the beachfront hotels behind me, wouldn't respond to any controls including Atti...

Yes multi flight mode enabled. I did not check mod values before takeoff. I do not check mod values before every takeoff. Compass calibrated on sidewalk. Yes, circular, half moon motion before taking off in straight line.

Don't recall the exact alert message but it had something to do with Update or Upgrade something...then immediately lost full control. It was an unnerving situation.

Not far but luckily it went up to 110 meters which helped to clear nearby hotel buildings. Flight record shows it flying all over the place.

1 fly-away out of 98+ total number of flights. Auto returned home safely.

Owned since January, 98 flights thus far with 1 fly away just last week during beach vacation. Immediately after takeoff (2nd battery, same location as 1st battery, flew 4 batteries day before from same spot) got a pop up message about "upgrade....", instantly no response to controls, including...

2.2 miles

Sent the whole thing since they're covering shipping cost. Besides, 4-6 weeks from now I don't want them coming back asking me to return something else.

Just couple days ago the video feed from camera stopped in mid flight in the middle of recording video. All pins were there and straight, rebooted tablet, remote, I1 several times, no video feed still. Tried again multiple times but no luck. Got through to DJI support tech after 30minutes of...

You may want to make one of these to keep gimbal and camera stable and stress free while transporting.

Not included. I use an old Dell laptop cord for 2nd DJI charger.

BLAADE RUNNE? Is this a hint referencing blade runner 2?

Experienced the same lag today with 1.0.1. Blade Strike says enabling Hardware Decode will fix this but haven't had chance to try. Then found issue with MP4 and ntsc. Deleted 1.0.1 and gone back to 0.9.2.

Yes, changing setting connected to Inspire. Rebooted TX, iPad Air, Inspire multiple times. Also happening when using iPhone 6. Looks like others are experiencing same with iOS App v1.0.1

v1.0.1. Can't change video mode to MP4 and NTSC. App reverts back to MOV and PAL. Anyone else?