I bought this drone used and it is Very clean but when I connected to the controller / DJI GO, I got this error *See image. Has anyone here had the same issue and what was the solution? I have ordered a replacement GPS module. I've tried to get to the center board and remove it to check the ribbon connection but its just too hard to get to. I see that the GPS module has a tiny battery on it (for memory I assume) and the voltage I measured on it was only .49 volts. Could this be the problem? Any schematics or instructions on how to disassemble this drone would be very much appreciated. TY.
Attachments
Last edited:
