So i just did 3 weeks of filming in mongolia and i noticed there is a bit of wiggle in the retract mechanism. Not a lot but just wanted to make sure it's normal as i don't remember this.
Check the connections from the lower transforming arms, there have been a few reports of the clamp that goes to the arm slipping and allowing the arm to move, the fix has been to put a washer or two under the clamp screw as it’s bottoming out.
Check the connections from the lower transforming arms, there have been a few reports of the clamp that goes to the arm slipping and allowing the arm to move, the fix has been to put a washer or two under the clamp screw as it’s bottoming out.
I checked that screw with the torx. It tightened down a little but i didnt wanna crank it and bottom it out and it helped a little...not much. Again this is a few mm of play. Not like i saw in one video where the whole side twists. mine is on one side it seems but the fact its minimal when its up makes me worry less.
Ok so i just disabled landing gear auto lock and checked it in its retracted position. There is the slightest amount of movement that probably doesnt matter at all when its up. Like a LOT less and it wasnt much to begin with.
I would not worry about that, it’s likely just loosened up a little with use , just triple check all the pins and c clips are in place and you will be fine .