Welcome Inspire Pilots!
Join our free DJI Inspire community today!
Sign up

Recent content by tammo

  1. tammo

    DJI Master Wheels working with Inspire 2 !?

    Hi! Just checking back on this in 2022. Anyone got this working? Can't find any info about it. I assume that the "DJI Masterwheels to Inspire 2 RC CAN Bus cable" that comes with the Masterwheels kit interfaces between the wheels and the 'slave' Cendence RC ? The master cendence is set for...
  2. tammo

    Recording times for a 480GB SSD

    Thanks guys. Yes, @Brett8883, that is the chart for 480GB but has alot of missing gaps. I've gone through all the H264/5 runtimes manually by inserting a MicroSD and seeing the recording times for each parameter. Would love to get an idea for the following based on a 480GB SSD: - ProRes 4444XQ...
  3. tammo

    Recording times for a 480GB SSD

    Hi Just wondered if anyone has a reference to recording times for a 480GB SSD in all the different codec and resolutions. At the DJI website there are a few examples but doesn't cover all the variations.. Many thanks!!
  4. tammo

    Slave Cendence controller link issues

    Update: my cendence has returned from repair and DJI have simply replaced the whole unit for a new one. I can't get any feedback to see what actually was the problem which would've been useful as a reference. But anyway....the new unit seems fine and working on the workshop bench. Will test...
  5. tammo

    Slave Cendence controller link issues

    Finally got out to test my I2 with both Cendences in Master and Slave mode with everything on the latest firmware. The remotes link (confirmed by the beeps) and the slave is able to operate the gimbal but constantly have the issue with the DJI Go4 app not recognising the slave remote on boot up...
  6. tammo

    Slave Cendence controller link issues

    Both Cendence's now updated and initially had a problem where the slave was linking but the DJI Go 4 app wasn't recognising the controller. Swapped out the Cendence CS Monitor mount and all good at the moment. Now need to go out and real world test it...
  7. tammo

    Slave Cendence controller link issues

    Hey thanks! I've just got back to the workshop and discovered the FW update. Will test and report back here. Fingers crossed x
  8. tammo

    Slave Cendence controller link issues

    Hi Just wondered if anyone has been having troubles with the Slave Cendence controller randomly unlinking from the Master Cendence controller during flight and on occasions on boot up? Have tried the following variants: - Boot I2, then boot Master Cendence, then boot Slave Cendence - Boot I2...
  9. tammo

    Unusual behaviour Cendence + 7" CrystalSky monitor

    Thanks. As soon as i'm back in the workshop i'll check and take some snapshots
  10. tammo

    Unusual behaviour Cendence + 7" CrystalSky monitor

    Hi! Just hoping for a little feedback or workarounds regarding a few issues i'm having. My setup is: Inspire 2 with X7, dual Cendence remotes, 7" UB Crystalsky monitors. All items have recently been updated to the latest firmware. - Cendence loses it's settings: changes from PAL to NTSC, video...
  11. tammo

    Licensed European Pilot flying Inspire 2 in the US

    Thanks! That perfectly answers my question. Much appreciated.
  12. tammo

    Licensed European Pilot flying Inspire 2 in the US

    Hi Just looking for some legal guidance regarding flying an Inspire 2 in the US. I am a Dutch national and will be on vacation in and around Nevada state, USA shortly. I hold a full drone pilot's licence in my country and fly my Inspire 2 professionally in Europe. During my travels I was hoping...