Recent content by Tim Stewart

My Rough Collies

I don't want to part it out. You can have everything for $250 plus shipping. 4 motors, damaged camera/gimbal. Would like to talk.

It looks pretty good. You want the arm also?

It's a v1 btw.

I seriously doubt it. Everything around the battery was on fire. Where is the light bridge located?

The left female coupler near the fuselage (left if calling the camera the front) is broken. The pipe itself appears to be ok. The main board was fried.

I'll send photos of what I have later today.

That memorandum is over a year and a half old.

Two thumbs up to that!

Be sure you have the DJI Go app NOT DJI Go 4 app

I wasn't aware that three controllers could be used. Curious to how you divide up the work. Is one for a director to just view?

Apparently, I did also!

I have an Inspire 1 v2. One poster claimed he used his x3 for video I assume because it flies smoother with less weight. Is it difficult to go back and forth between the X3 and X5? Do you ave to apply the firmware each time you switch? If you can go back and forth, it would be great if you could...

Yes, that is my experience. Only a warning.

Those of you have roll calibration issues, how far is yours off and is it consistent? Mine is off + 1.2 every time. I test by leveling across the prop mounts via a 24" accurate level. Level the by putting spacers under the legs. I set the level about a foot in front of the camera (leveled) then...