I've got my I2 2nd controller. We've followed the sequence of master/Slave binding. We are able to see camera on 2nd controller but it says it is not connected to the aircraft. Any troubleshooting advice?
I've got my I2 2nd controller. We've followed the sequence of master/Slave binding. We are able to see camera on 2nd controller but it says it is not connected to the aircraft. Any troubleshooting advice?
So we figured it out after much time. We switched all the pieces around - iPads/controller. The results for some reason was that the after rebinding - the "A" controller now is the "B" controller and all works well now. Yay!
Hey all, just wanted to chime in, that after similar finagling, I was able to get the dual control setup to work. However, I'm back into into it now getting ready for a demo flight tomorrow, and it's not working. I'm going to keep finagling, but if anyone has any suggestions for fixing this for good, I would appreciate hearing from you.