Hi I got a new to me Inspire 1 x3 camera which I crashed on its maiden voyage.I have had it repaired then went through problems with firmware upgrades and to keep this short eventually landed up with Inspire 1 Firmware v1.3.0.00 which took care of all the error messages about needing to update firm ware.Everything looked fine to go and then got a gimball motor overload error.When the drone is powered up it goes through the self check the camera moves all over the place and then rests in a for lack of better words a limp state and shows nothing on the go app camera screen.Would this still be a firm ware problem.The text log after upgrade reads 800 device not detected and 1500 devise not detected
Last edited: