Bad x3 camera

[NH Phantom]

I just picked up another inspire 1. Couldn't connect because of a bad controller. Replaced the controller and now the ac works fine. camera is a different story. Camera initializes properly. Gimble works up and down with the controller as it should but getting no transmission signal. contacts look good on the connection board. Tried on another Inspire and same thing. Tried a known good camera on the new AC and it works ok so its definitely the camera. Any ideas on what it might be? Camera looks mint, not a mark on it. Maybe a new connection board to start off with? Where can I get a new board?

 

[NH Phantom]

So much for that idea. Swapped out the connection boards. Still same problem. Any other suggestions?

 

[The Editor]

I just picked up another inspire 1. Couldn't connect because of a bad controller. Replaced the controller and now the ac works fine. camera is a different story. Camera initializes properly. Gimble works up and down with the controller as it should but getting no transmission signal. contacts look good on the connection board. Tried on another Inspire and same thing. Tried a known good camera on the new AC and it works ok so its definitely the camera. Any ideas on what it might be? Camera looks mint, not a mark on it. Maybe a new connection board to start off with? Where can I get a new board?

See the thread HERE (my post #4)

Since you have already tried the new connection board I'm afraid it means a new X3.