Battery Error - Voltage is fine?

[droneondemand]

Good Afternoon All,
Anyone have any thoughts on this? Last flight, all my other sets of batteries worked but this one...Seeing "Battery Cell is Broken" message, but all cells look fine?
Have not done new firmware update on I2 or Go4.
Thanks,
Patrick

 

[ringolong]

I have a set that gives me the same error. One cell is a little lower than the others is the only issue I see. One was at 4.22 while the others were at or above 4.30. I did notice that when they had discharged to 68% they were fine again, but when I fully charged them the error was back.

 

[Joemandoo]

Had the same issue. Tried many work arounds but just replaced it for safety sake.

 

[droneondemand]

So just wanted to post an update to this issue...
I decided to bite the bullet and update to the new firmware. Did the bird, controller and all batts...
Guess what? It's now fixed the "Cell Error" and the three batts that were down are all now reading fine...
Weird huh?

 

[ringolong]

I read that the firmware update was correcting the errors. Thanks for the update!