Battery Error

[J.T.]

Hi All,

Finished flying last night with 25% battery left. This morning tried to charge the battery but get three pulses from the first LED only. I disconnected the battery from the charger and now it won't switch off at all. Has any one else seen this error.

Thanks.

 

[Tahoe Ed]

Check page 22 of the Inspire manual.

http://download.dji-innovations.com/downloads/inspire_1/en/Inspire_1_User_Manual_v1.2_en.pdf

 

[J.T.]

Check page 22 of the Inspire manual.

http://download.dji-innovations.com/downloads/inspire_1/en/Inspire_1_User_Manual_v1.2_en.pdf

Thanks Ed,
It seems if it was LED 3 blinking three times it would be over voltage from the charger, which is the stock unit. I can't see anything about LED 1 blinking.

I've sent a message to DJI Europe, will report back what they say,

Thanks again.

 

[robshaw]

Did you hear anything back on this? I also have the 1st led blinking and so does a mate on two of his batteries!? None of them were run lower than 30%.....

 

[J.T.]

Did you hear anything back on this? I also have the 1st led blinking and so does a mate on two of his batteries!? None of them were run lower than 30%.....

Not yet Rob, hoping they'll get back in the morning.

 

[robshaw]

I've just pulled the top off mine and disconnected the balance lead for half an hour. It's now ok. Phew. Seems it's the much talked about firmware issue.

 

[britchris1]

If the battery temp is too high the first led will blink when you attempt to charge it. Let it cool for about 5 minutes and it will be fine.

 

[J.T.]

Quick update, Battery replaced under warranty by DJI.