Hello everyone.
I'm new here, posting a question for my husband from Japan. We've been looking around the web for answers and can't find what we're looking for so I'm hoping someone here can help us. I'm not very good with the technical terms and drone terminology but here goes.
We have an Inspire 1, purchased in Japan. My husband tells me it uses a 2.4 GHz antenna while other models (from countries other than Japan) use a higher frequency. The max flight distance is about half of what the US model gets. We've installed the DBS antenna to get more distance but it's still not getting the boost we were expecting.
We're open to just buying a whole new set up if we have to, but with importing costs it's quite expensive. If possible we'd like to just change the internal components to US versions but we're not sure if this would work, and we're not sure what to change. I'm assuming the antennas to start, but what else?
We also don't know if we'd need a whole new controller or not.
We have taken apart the whole drone, for waterproofing with corrosion x, so the difficulty isn't really an issue.
Any advice would be appreciated! TIA!
I'm new here, posting a question for my husband from Japan. We've been looking around the web for answers and can't find what we're looking for so I'm hoping someone here can help us. I'm not very good with the technical terms and drone terminology but here goes.
We have an Inspire 1, purchased in Japan. My husband tells me it uses a 2.4 GHz antenna while other models (from countries other than Japan) use a higher frequency. The max flight distance is about half of what the US model gets. We've installed the DBS antenna to get more distance but it's still not getting the boost we were expecting.
We're open to just buying a whole new set up if we have to, but with importing costs it's quite expensive. If possible we'd like to just change the internal components to US versions but we're not sure if this would work, and we're not sure what to change. I'm assuming the antennas to start, but what else?
We also don't know if we'd need a whole new controller or not.
We have taken apart the whole drone, for waterproofing with corrosion x, so the difficulty isn't really an issue.
Any advice would be appreciated! TIA!
I assume the MIC compliant note is in regards to your local laws. Back to your original question. I don't know, but I guess the TX and RX part in both the craft and the RC is different to being able to work with that different frequency. On the other hand. Your booster seems to make it work as good as the US version.
