Inspire Balance Rods Are Here

No, we ran out of stock a few days ago. We hope to have some more next week.
 
From what I have seen, it looks like the prop locks will affix over the entire assembly attaching to the motor so it will not be on the prop permanently. I don't have a picture I can post yet but if I get one I will post it.
 
ALL e RC said:
From what I have seen, it looks like the prop locks will affix over the entire assembly attaching to the motor so it will not be on the prop permanently. I don't have a picture I can post yet but if I get one I will post it.
Click to expand...

Ahhh... OK, understood.

Thanks
 
This is the locks:
 

Attachments

  • uploadfromtaptalk1422009898249.jpeg
    20.8 KB · Views: 33
  • uploadfromtaptalk1422009914105.jpeg
    11.9 KB · Views: 30
  • uploadfromtaptalk1422009926914.jpeg
    36.6 KB · Views: 34
  • uploadfromtaptalk1422009937663.jpeg
    25.6 KB · Views: 30
I've got a stupid question on the balance rods. If the prop is out of balance what do you do to it?
 
I'd like to see a picture of these balance rods. Do they work with the other quads (FC40, Phantom, etc.)
 
FASTFJR said:
I've got a stupid question on the balance rods. If the prop is out of balance what do you do to it?
Click to expand...

Not a stupid question. Most people add some tape to the light side (back side of prop) to balance it.
 
2014fc40 said:
I'd like to see a picture of these balance rods. Do they work with the other quads (FC40, Phantom, etc.)
Click to expand...

We have a picture on the website. The Inspire balance rod only works on the Inspire props as they have a smaller diameter thread then the original phantom/phantom 2 props. The Phantom prop balance rods are also linked below (with a picture). They are both polished aluminum and work great on the Dubro balancer.

Inspire balance rod:
http://www.allerc.com/orion-rc-balance-rod-for-dji-inspire-self-tightening-propellers-p-9782.html

Phantom balance rod:
http://www.allerc.com/orion-rc-bala...vision-self-tightening-propellers-p-9458.html
 
Thanks Adam. We are finally getting some hours on our Inspire at the shop and are trying out the new FatShark Dominator HD's this weekend. So far, pretty impressed with the setup.
 
I just got mine in the mail yesterday Thanks....
as far as balancing goes, I just use a dab of CA glue and excelerator on the light side...
 
Last edited:
You must log in or register to reply here.

Similar threads

I
Balancing Harness Conversion TB47/48
Replies
11
Views
2K
Inspire 1 Discussion
Donnie Frank
RC Plus for Inspire 3 - Open Box - Never Activated or Initialized - $1400
Replies
0
Views
252
Classifieds
Florida Drone Supply
G
Inspire 1 Pro for sale
Replies
1
Views
802
Classifieds
Ghostrider
G
E
Dji Inspire v1
Replies
0
Views
847
Classifieds
extreme24
E
DJI Inspire 1 PRO - PLUS Flir Zenmuse XT Camera & Zenmuse X5 Camera ($2895.00)
Replies
2
Views
1K
Classifieds
FlFlyer
Menu
Log in
Register