Haven't had the I2 out of case for over a month, been busy working on the Matrice 600Pro.
Last time flew, no issue... flew fine, behaved fine, recorded video fine.
Thought I check firmware and take it for a short yard flight.
The DJI4Go App connected with no messages of FW updates, only a Zone Update.
Found GPS Satellites and reported Home Point & Ready for takeoff.
Performed CSC, motors spin up, and just barely hear the "Take Off" and all motors stop.
Tried this several times (3-4 times), each time the motors stopped 2-3 seconds after starting.
Shut it all off, RC, Tablet, I2. Removed Batteries... Restarted - Same results, Motors start for 2-3 seconds then shutoff.
Flight Logs only indicate the normal warning for my home area, indicating Close to a Zone type message.
Connected to Computer and DJI Asst 2, showed current FW.
Performed a "refresh" and uploaded & installed the FW.
Finshed with same version indicated.
Retested and it starts up fine now.
Anyone have this issue?
What causes it, does the FW get corrupted?
Last time flew, no issue... flew fine, behaved fine, recorded video fine.
Thought I check firmware and take it for a short yard flight.
The DJI4Go App connected with no messages of FW updates, only a Zone Update.
Found GPS Satellites and reported Home Point & Ready for takeoff.
Performed CSC, motors spin up, and just barely hear the "Take Off" and all motors stop.
Tried this several times (3-4 times), each time the motors stopped 2-3 seconds after starting.
Shut it all off, RC, Tablet, I2. Removed Batteries... Restarted - Same results, Motors start for 2-3 seconds then shutoff.
Flight Logs only indicate the normal warning for my home area, indicating Close to a Zone type message.
Connected to Computer and DJI Asst 2, showed current FW.
Performed a "refresh" and uploaded & installed the FW.
Finshed with same version indicated.
Retested and it starts up fine now.
Anyone have this issue?
What causes it, does the FW get corrupted?