Howdy,
I pulled the trigger and rolled my Inspire 1 firmware back to v01.08 from the derided v 01.11.... During the dirty deed the X3 started to really bang hard from side to side, this was after the four motors blinked red and downgraded. I let it run for 45 minutes and checked the SD card . Still upgrading. I reformatted the card with FW v1.11 to put everything back.
Today I have it at 1.11.01.50 and controller at v1.7.80. I can control the AC and connect with app butt the X3 is dead. I see NO line item for the Camera FW in the Go app. No Gimbal as well as feed. Some how I lost the FW on the X3 or it shook its self to death. If i put a formatted Sd card in with only debug and FW and try again.. the X3 dose not move at all but I see other folders (DCIM, MISC) writtin back on the card. so Could this still be a Connection Issue ? I have tried the X3 on the Osmo as well .. Go app connects with Osmo but No X3 feed
I pulled the trigger and rolled my Inspire 1 firmware back to v01.08 from the derided v 01.11.... During the dirty deed the X3 started to really bang hard from side to side, this was after the four motors blinked red and downgraded. I let it run for 45 minutes and checked the SD card . Still upgrading. I reformatted the card with FW v1.11 to put everything back.
Today I have it at 1.11.01.50 and controller at v1.7.80. I can control the AC and connect with app butt the X3 is dead. I see NO line item for the Camera FW in the Go app. No Gimbal as well as feed. Some how I lost the FW on the X3 or it shook its self to death. If i put a formatted Sd card in with only debug and FW and try again.. the X3 dose not move at all but I see other folders (DCIM, MISC) writtin back on the card. so Could this still be a Connection Issue ? I have tried the X3 on the Osmo as well .. Go app connects with Osmo but No X3 feed
Last edited: