1.3 BIN file needed for RC

[Polkiejoe]

need to update a slave RC up to 1.3 BIN firmware or later. I can't find this file anywhere? Could someone point my in the right direction please? I've also used the search function but couldn't get a good answer

 

[The Editor]

need to update a slave RC up to 1.3 BIN firmware or later. I can't find this file anywhere? Could someone point my in the right direction please? I've also used the search function but couldn't get a good answer

I can't vouch for them but try here.
http://www.panorobot.com/dji/inspire_firmwares.htm

 

[Polkiejoe]

Thanks so much! I'll give it a try

 

[Polkiejoe]

Well the rc reset bin worked but can't seem to get 1.3 or above to install the firmware. 2.6 or lower installs again. I get a constant red blinking light with the stick calibration warning. Try to calibrate sticks but it won't even start the calibration process try to to a hard reset and won't do that either... just keeps blinking red and the constant beeps

 

[george.sealey@btinternet.]

I can't vouch for them but try here.
http://www.panorobot.com/dji/inspire_firmwares.htm

No good the bin file is not in the Zip for 1.3 !!!!! so frustrating