single remote. Everything else seems fine. Full tilt with the wheel. Yaw and tilt with the finger (blue circle) works good.
This is a strange one as I have not come across this before.single remote. Everything else seems fine. Full tilt with the wheel. Yaw and tilt with the finger (blue circle) works good.
No, ignore that message. Its a bug in the app that will be addressed in the next version. The gimbal calibrates fine.Tried that with no success. I just noticed that I get the message "gimbal calibration failed" when I turn on the Inspire. I didn't notice it before because I was starting the app after the Inspire. Looks like I might be returning this machine.
No, ignore that message. Its a bug in the app that will be addressed in the next version. The gimbal calibrates fine.
I still think it is something you are not doing.
If you remap the buttons to another function (bring up battery info eg) does that work?
If not then the button(s) themselves (or connector to them) maybe faulty.
They work fine remapped. Even the when I use the finger to pan the camera, when I press the "reset gimbal yaw" it recenters like it should. I switched the c1/c2 functions to no avail. I did an RC recalibration. RC function is set to Master. Not sure what else to try but I am sure open to some ideas. I took it out for a test flight and everything on that end worked great.
This is not o. FW v1.2.1.0 though. It is an app bug.After update. i flew 5 flights . unable to retain the Return to home height(in case of failure) it reverts back to 0 ....it is a confirmed Bug by DJi (dji Autumn) and dangerous one! Dji autumn is saying that it is not displayed but the aircraft retains it i am not sure because i have not tested it.
my apologies if i have posted it before,... i just think if it is not retaining the height the results in an emergency will be catastrophic at ht of 0 ft.
You need to climb to a few meters high then come back down, if you stay low it won't come down by itself. Always been like that (it would otherwise just go back down right after going up).I think the issue is if you take off with auto take off then try and land, most of the time I have to manually put the gear down. Some times I have been hovering 6 inches off he ground and still no lowering
Have you tested the fact that:This is not o. FW v1.2.1.0 though. It is an app bug.
Confirmation from DJI......Test it for yourself, its pretty easy and safe to do in an open area!Have you tested the fact that:
The aircraft retains the RTH height Even though it does NOT display on the app? or are you taking DJI's word for it?
We use essential cookies to make this site work, and optional cookies to enhance your experience.