Inspire 1 v2 image transmission issue

[tushayjf]

Hello guys,

I know this is an old topic but I have been busy with work and travel and have not had a chance to look into this issue further.

Does anybody have a solution for image transmission issue?

Any help will be greatly appreciated.

Thank you!

 

[Michael sullivan]

Same issue here , fine out to 1600'. But turn around and breakup of Transmisson occurs every time tried swapping connector cords and even swapped out the controller plugs no dice

 

[Donnie Frank]

Take your bird's firmware back to 1.08.30 and your controller back to v1.6, and leave them there. The results will be instantaneous.

 

[Lloyd]

Take your bird's firmware back to 1.08.30 and your controller back to v1.6, and leave them there. The results will be instantaneous.

Do these versions work well with the battery/voltage quirks? I had a scare yesterday with the motor overload/low voltage warnings and a forced landing.

 

[Donnie Frank]

Do these versions work well with the battery/voltage quirks? I had a scare yesterday with the motor overload/low voltage warnings and a forced landing.

All "quirks" were fixed in v1.08.30. I have been flying v1.08.30 since June of last year and it's been rock solid. I have about 40 hours of flight time on my bird.

D